60Patrol

Greetings all those with Floor Mat & Bed Mat envy,

Plateaucal spurred me on to contact Anspira in Columbia to see if he could source or make floor & bed mats for me/anyone who needs them. He said he could and he would make the pattern on his AutoCAD machine so I think we are in business.

Now..here is where I need help....as usual. If anyone has the geometry of an original floor mat it sure would be appreciated. Not sure how we identify the holes for the shifters? I assumed he owned a Patrol but does not. Any ideas?

As helpless as I usually am.... will endeavor to learn how to use a yardstick and measure the bed area geometry myself. Naturally I will buy a half dozen yard sticks so I can cut them to fit the length and width precisely end to end so I can get one continuous measurement for accuracy.

I'll take the first three sets.

Making Patrols Great Again,
L60Boerne

Since the trans cover mat isn't flat it will be tricky to convey a pattern. It almost needs to be 3-D.

I have factory rubber mats and the tranny cover.

Thanks Volkman, now how can you make a pattern? Maybe we give him the outside dimensions and the we cut our own holes?

Just thinking.....

L60BOERNE Boerne

I hope this works. I think pretty much all of us could use a set of mats.