Paul's 1967 Restoration

by **jwgreen** » Sat Jul 02, 2016 7:56 am

Not anymore, Datusansocal had them but his is no longer on this earth, RIP MIKE, so now I don't know of another source. If only we could get his sources for all those parts.....

by **Esteban** » Sat Jul 02, 2016 5:28 pm

jwgreen wrote: If only we could get his sources for all those parts.....

I understand that he was making the rubber parts... So sad.

by **pdub** » Wed Jul 06, 2016 9:49 pm

Yes, so sad about Mike.

by **pdub** » Wed Jul 06, 2016 10:00 pm

So last week I go looking for my radiator on the side of my house. I reach down to pick it up and see fur while looking through the fill hole. Turns out a rat decided to make a home in there then die. After pulling him out and washing out the leaves etc. I took it to the local radiator shop for a check up. Passed with flying colors. This past week end I mounted the generator, radiator and front sheet metal. I am going to start the engine for piece of mind before starting on the bodywork.