by Oddbod » Sun Nov 17, 2019 12:42 am
Well folks, its been a while.
Between life, a spell of hot weather and a lack of motivation, I have now got a new idea and have started implementing it.
Well, 2 ideas actually;
1st is a slightly modified hinge design, nothing drastic, but it appears that it may offer some extra lift at the rear.
2nd I have decided to do a mock up on my old wooden engine bay buck and use it to make any hinge position tweaks.
Attached are a couple of pic's of the hinges in place as per the real engine bay, with the exception, I have moved the hinges in from the outer edge by 1" and raised them 3/8".
I can not give a detail explanation for this move, other than to say I am going with my gut right now.
Fingers crossed again...
You do not have the required permissions to view the files attached to this post.