Hi all,
I found something that works pretty well for the screw in seal where the bottom of the doors meet the floorpan - thought I'd FYI you ...
The thickness of the tongue is just right to slide into the groove provided by the edge of the floorpan too
I re-used the same holes that were already there for the original seal which has been long gone... I just got new sheet metal screws & washers.
McMaster p/n 1142A82
https://www.mcmaster.com/#1142a82/=158k63l
See install pics below:
Lower Seal - Front Doors - FYI
-
- You know you own a Patrol when…
- Posts: 120
- Joined: Mon Jul 14, 2014 9:09 am
- Location: Los Angeles
- Has thanked: 42 times
- Been thanked: 73 times
- Contact:
Lower Seal - Front Doors - FYI
You do not have the required permissions to view the files attached to this post.
-
- Administrator
- Posts: 7817
- Joined: Thu Oct 04, 2012 10:42 am
- Location: Temecula, CA
- Has thanked: 7696 times
- Been thanked: 2477 times
- Contact:
Re: Lower Seal - Front Doors - FYI
That's great. I think yours was one of the few that still had enough remnant of the original to cross reference from. Thanks for sharing!
Beyond any hope for intervention
-
- You know you own a Patrol when…
- Posts: 127
- Joined: Tue Sep 23, 2014 10:18 pm
- Location: Dunnigan, CA
- Has thanked: 131 times
- Been thanked: 147 times
Re: Lower Seal - Front Doors - FYI
Eric,
Thanks for that! Just ordered the rubber and some nice stainless steel screws and washers from Mcmaster Carr. It looks like a great fit.
Rick
Thanks for that! Just ordered the rubber and some nice stainless steel screws and washers from Mcmaster Carr. It looks like a great fit.
Rick