looking for seals and gaskets for transfer case aneyone

npca-jerry-n.w · Post by **npca-jerry-n.w** » Mon Oct 22, 2001 9:04 pm

Doe's aney one know were I can get them?.....part number? thanks for your help

npca-gary · Post by **npca-gary** » Sun Oct 28, 2001 5:30 pm

Jerry, Just rebuilt my transfer case last spring. I just took the seal to my local parts house and the used the numbers off of the seal to get the new ones. Gaskets are easier. Buy sheet gasket material the same thickness as the one you removed. Lay the sheet against the part and tap gently ,with a hammer, through through the gasket material, around all the inside and outside surfaces including the mounting holes. This will mark and even cut the material well enough to make your own gasket. Incidently, you can generally get your bearings from the numbers off of the old bearings.

npca-jerry-n.w · Post by **npca-jerry-n.w** » Sun Oct 28, 2001 10:37 pm

Thanks Gary I'll give that a try. My T case is just leaking oil. The only other seal I can't find is the front axl closed u-joint seal [where the front wheels turn] I think this is a two peace seal any ideals here .Thanks Jerry....................Grate club.......................