Compatiple wheels

npca-ineedabrew · Post by **npca-ineedabrew** » Tue Mar 13, 2007 9:30 pm

Anyone have suggestions on what kind of wheels that will fit a 69 L-60 patrol. I have the original tires and rims on and want put something else on..... I am sure someone has put a rims and tires on from another type of vehicle? Thanks!

npca-patrolster · Post by **npca-patrolster** » Wed Mar 14, 2007 11:11 am

I recall back in the day I bagged some wheals off a late 70's toyota pickup truck. They fit perfectly. They were the stock wheals a guy had changed out. Good luck.

npca-67l60 · Post by **npca-67l60** » Wed Mar 14, 2007 2:29 pm

just take some measurements off youre existing wheels , factory offset of 4 inches max . fj40 wheels will work butt expect thing to break due to added weight and maybe rubb if youre to wide if youre looking for modern wheels just about any 6 bolt toyota or nissan will work just watch youre width 8 /10 wide will definitely need a serious 3 inch lift and id keep at least 6 wheel studs in my pocket to replace them as they break and maybe a couple short axles and wheel bearings galore if you plan on wheeling it the rear wheel bearing are a b...tch and are prone to going out with stock set butt they do look good sitting on 34X12 s just not very practical whith a top speed of 45

npca-ineedabrew · Post by **npca-ineedabrew** » Tue Mar 20, 2007 3:04 pm

Thanks guys......I found some decent ones on Craigslist here in Atlanta from a 97 Nissan pickup truck for $125.....not bad tires are decent too....... Thanks for your help! Jason

npca-67l60 · Post by **npca-67l60** » Wed Mar 21, 2007 1:05 am

well post some pics either here or on rmpo site what year is youre patrol

npca-ineedabrew · Post by **npca-ineedabrew** » Sun Mar 25, 2007 9:13 pm

Its a 69 L60........she ain't too pretty but runs good!! Attachment: Copy of Patrol 01.jpg

npca-riverpatrol · Post by **npca-riverpatrol** » Mon Mar 26, 2007 10:46 am

Not too bad looking, really. Definitely has potential. Hnag on to those old wheels - they are the original split rims.

npca-67l60 · Post by **npca-67l60** » Mon Mar 26, 2007 4:12 pm

well it may need a little work butt its 99%all there which is very rare the side steps dont loose them worth big money floor boards can be found you just need to ask around also its a mid year more in comon with a 68 than a 69 with very little work you could have a show truck after a little buffing and scrubbing is all it would take and a few body parts butt heck i keep finding parts rigs missing 90% of everything the front bumper isnt stock butt they usually get damaged and swapped out there is a parts rig listed in tucson in the for sale section call him all you need is there just make a offer good luck ps if you have the hubcaps dont loose them really big money in those

npca-patrolster · Post by **npca-patrolster** » Tue Apr 03, 2007 12:35 pm

Were did you get this Patrol? And were are you? I swear this looks like my old patrol that I owned in the late 70's. I recognize that c-channel bumper. Does it have a small hole on the driver side front quarter panel?