Page 1 of 10
Tool box
Posted: Sun Jun 09, 2013 12:02 pm
by Coyote Patrol
Any chance someone could post some pics of a tool box? I need a pic of the hinge, pic of box closed and box open. Also the measurements. Depth, width, length, and also measurement of the separator
. Im going to try and fab these. Thank you.
Re: Tool box
Posted: Sun Jun 09, 2013 12:18 pm
by Esteban
I "borrowed" this pictures from another place. Hope it helps:
Tool box 1a.jpg
Tool box 2a.jpg
Dimensions
Length (outside): 13-5/8"
Width (outside): 8" (
edit)
Depth (top open): 2-3/4"
Separator at back: 2-3/4"
Separator at front: 1-3/4"
Depth of separators: 2-1/2"
Re: Tool box
Posted: Sun Jun 09, 2013 7:23 pm
by Coyote Patrol
Could you get me a pic of the handle, and clasps please. Thanks Esteban
Re: Tool box
Posted: Sun Jun 09, 2013 8:56 pm
by RiverPatrol
Here's some:
Re: Tool box
Posted: Sun Jun 09, 2013 9:08 pm
by Coyote Patrol
Thank you, where the handle goes into the box, was that pressed into the box? (like a louvre)
Re: Tool box
Posted: Mon Jun 10, 2013 12:17 am
by bosque
About the 6th shot down has another angle.
You are going to make the uber unobtainium toolbox not so impossible to have!
http://www.60patrol.com/forum/viewtopic.php?f=33&t=1937
Re: Tool box
Posted: Mon Jun 10, 2013 12:20 am
by Coyote Patrol
Im gonna give it a shot, i have a lot of catching up to do, so it will be a while.
Re: Tool box
Posted: Mon Jun 10, 2013 9:45 pm
by Coyote Patrol
Re: Tool box
Posted: Mon Jun 10, 2013 11:24 pm
by RiverPatrol
You're off to a great start! Very impressive.
Re: Tool box
Posted: Tue Jun 11, 2013 12:19 am
by bosque
Ron,
So out of curiosity, do you actually make a nissan emblem and then press or emboss it into the sheet metal?
It is so cool to see you doing this stuff, I wish I were a fly on the wall.
