Page 1 of 2

Feeler- 69 engine, drive train, axles, suspension

Posted: Tue May 17, 2016 2:30 am
by Nisstec
Hello, new to the forum and a new owner of a 1969 hardtop. Going a different route with the build on this one and will have quite a few parts available soon. After a quick tune-up I've been daily driving the Patrol the past few days. Happy to take pictures and video of everything running and driving prior to selling any of it. I don't intend on digging iinto the build for a few months but figured I'd get some feeler out on parts that will be available.

Engine- Runs great, No smoke, waterproof dizzy, new plugs coil and wires. Holy carb that says it was rebuilt in 2012. The carb could use a little bit of work. Haven't done a compression test but willing to do so and document it. Top end is pretty clean. Valve cover leaks a bit and rear main has a few dribbles.

3 speed trans and transfer case- 1st synchros are a bit rough. Other than that it shifts smooth and drives good

PTO and old school Warn winch. No winch cable.

Front and rear driveshafts

Front and rear axles and suspension

Front 60/40 and rear jump seats. Need new foam and covered.

Front seatbelts. In fair need to be cleaned codition

Gas tank- hadn't checked the condition inside
That's a start. Basically I'm keeping the body land frame

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Tue May 17, 2016 10:08 am
by RiverPatrol
Sure, post up some pics and video. It would be nice to get the VIN and engine numbers to add to the Registry for posterity, too.

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Tue May 17, 2016 12:20 pm
by mdawg4x4
Welcome to 60Patrol.
Curious as to what direction you will go with the drive train.
I have 2 Patrols that I picked up basically for retirement projects.
1 had a fairly clean body for the south and I would like it to stay as close to stock as possible, but for now needs more work to get running than the other one.
The other one has body damage, but is the one I am trying to get running just to drive on occasion until I can put a Nissan 4.0L, tranny, Atlas II, and modern suspension under. For the next several years, though, it will remain stock set up.

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Tue May 17, 2016 4:40 pm
by mad4hws
I have a '73 and am interested in the winch/PTO. Wondering if the '69 parts would work on my '73? Also count me in on the front seat belts.

Thanks.
Don.

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Tue May 17, 2016 6:54 pm
by Esteban
mad4hws wrote:I have a '73 and am interested in the winch/PTO. Wondering if the '69 parts would work on my '73? Also count me in on the front seat belts.

Thanks.
Don.
They will. All the mechanicals are interchangeable, specially if it is a complete assembly rather than parts within it. Patrols have changed very little over the years.

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Wed May 18, 2016 10:07 pm
by weasel451
Hey nisstec, I'd definitely be interested in your rear seats...I don't have anything so even frames are a great starting point. Thanks, Darren in Louisville, KY.

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Thu May 19, 2016 12:43 am
by Mattbob53
I'd be interested in a lot of the parts for spares, but really looking for

parking break assembly
Transmission

Send me a pm



Matt

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Thu May 19, 2016 11:36 am
by mdawg4x4
PM sent about front seats.

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Tue May 31, 2016 5:02 pm
by Timoun
Hi-

I might be interested in the front axle if shipping to California isn't cost-prohibitive.

Thanks!

Timoun

Re: Feeler- 69 engine, drive train, axles, suspension

Posted: Wed Jun 01, 2016 1:07 pm
by ckhorne
I'd also be interested in the transmission and the parking brake assembly, but I see Mattbob53 may have already beaten me to both.

Add me to the list, I suppose...