New Autometer Gauges

[seth1001]

Just posting a mod I did with new electronic Autometer gauges. I think they look pretty damn good...and they work good too. Let me know if you have any questions or comments. Thanks.

[mad4hws]

that does look really really good.

[mdawg4x4]

I like it. I have contemplated the same, but have not gone that far yet.
What are the 4 gauges in the single large cluster? And what are the 3 additional individual gauges?
How did you calibrate the Speedometer/Odometer? And what is it reading? Drive shaft rpm?
How did you calibrate the fuel gauge?

[Esteban]

Just posting a mod I did with new electronic Autometer gauges. I think they look pretty damn good...and they work good too. Let me know if you have any questions or comments. Thanks.

They do look very good. Congratulations!

[Johnny Roadkill]

Look great - classic style with modern reliability! Neat install too, nice job.

I'd like to see a tacho personally, but need to find one that tops out at 5k rpm instead of 10, lol.

Cheers,
D

[Esteban]

Look great - classic style with modern reliability! Neat install too, nice job.

I'd like to see a tacho personally, but need to find one that tops out at 5k rpm instead of 10, lol.

Cheers,
D

I have one of these installed in mine for close to 20 years. Extremely accurate since I've tested it with a mechanical tach applied to the crankshaft pulley bolt:
http://www.datcon.com/en-us/products/ta ... p-n-100230

It max out at 4000 rpm. Unless you do some crazy mod , impossible to surpass that limit.

[Johnny Roadkill]

Thanks Esteban, and for a good price too...even the name has a Datsun flavour, lol. And yes, short of a rebuild including replacing the conrods with custom forged items you'll never bend the needle on the stops

Those Autometer gauges do look really nice though - suit the Patrol well, very classy.

Cheers,
D

[seth1001]

I like it. I have contemplated the same, but have not gone that far yet.
What are the 4 gauges in the single large cluster? And what are the 3 additional individual gauges?
How did you calibrate the Speedometer/Odometer? And what is it reading? Drive shaft rpm?
How did you calibrate the fuel gauge?

The quad gauge has coolant temp, oil px, voltage, and fuel. The 3 individuals are a tach gauge, a clock, and another fuel gauge. The speedometer is fully electronic so you can calibrate it by pushing the button in a specific way and driving 2 miles. It's spot-on according to GPS speed as shown on my phone. In the photo the speedometer was just stuck at 5 mph or something because that's how it was shipped from the factory. As soon as I powered it on for the first time it reset back to zero. It's just a hall sensor that replaces the speed sender in your transmission. I chose the fuel gauge for a 0-90 ohm sender, which I purchased but haven't installed in the tank yet. The fuel gauge in the quad will be rigged to show fuel in the main tank, and the extra one will show how much fuel is in my auxiliary fuel tank. The whole setup wasn't too cheap but I think it's been worth it so far.

[mdawg4x4]

Did the speedo and quad gauge fit the existing opening?

[Johnny Roadkill]

My apologies, I didn't realise that was a tach - the needle sitting at half span fooled me into thinking it was an ammeter

Cheers,
D