Re: Name that part!
Posted: Sat Feb 02, 2013 4:15 am
Is it the rubber that goes between the carb intake and the lid of the oil bath?
60Patrol
An open forum for all enthusiasts of the classic 60 series Nissan Datsun Patrol to gather and share information and gain knowledge. Members share off-road stories, restoration advice, modification ideas in an atmosphere free of a single controller. The fo
https://60patrol.com/forum/
Name that part!
Page 5 of 41
Re: Name that part!
Posted: Sat Feb 02, 2013 9:58 am
I must agree with Tim as I just put a new one on my my Patrol with the new carby a few months ago. Till Leslie gives the nod heres a patrol part for ya to ponder. Poor pic but a gears a gear...
Re: Name that part!
Posted: Sat Feb 02, 2013 11:15 am
Winner, winner, winner! Miller's next.miller wrote:Is it the rubber that goes between the carb intake and the lid of the oil bath?
Re: Name that part!
Posted: Sat Feb 02, 2013 2:39 pm
Odometer drive gear.miksum56 wrote:I must agree with Tim as I just put a new one on my my Patrol with the new carby a few months ago. Till Leslie gives the nod heres a patrol part for ya to ponder. Poor pic but a gears a gear...
Re: Name that part!
Posted: Sat Feb 02, 2013 3:48 pm
Very good LeslieRe: Name that part!
Posted: Sat Feb 02, 2013 3:49 pm
I know its Tims turn but we killed a little time while he sleeping in OZmiksum56 wrote:
Re: Name that part!
Posted: Sat Feb 02, 2013 4:32 pm
Fourth page of posts on this sure came fast 
Hey Mike that was a good one, I would not have known nor ever seen one.Thanks.
Hey Mike that was a good one, I would not have known nor ever seen one.Thanks.
Re: Name that part!
Posted: Sat Feb 02, 2013 8:24 pm
Thanks Dave. It sits on end of shaft next to the 1/10 mile spool just out of site of your viewing the odometer; I had to be careful with a end only view to hide the 6 numbered spools.
Re: Name that part!
Posted: Sat Feb 02, 2013 8:56 pm
miksum56 wrote:Thanks Dave. It sits on end of shaft next to the 1/10 mile spool just out of site of your viewing the odometer; I had to be careful with a end only view to hide the 6 numbered spools.
Went and took a pic...PS) Its unlawful to reset these mine just happened to break at 000000 
Re: Name that part!
Posted: Sun Feb 03, 2013 2:24 am
RiverPatrol wrote: Winner, winner, winner! Miller's next.
Ok heres the next one...