Pancho and his Patrol
Posted: Wed Jul 24, 2013 10:07 am
Hi everybody,
I am Pancho another Patrol addict as Esteban says
and a very proud owner of my 48 years old rig. Actually it is older than me and has been in the family since it was bought from the Nissan dealer here in Ecuador. Just two months ago I finish the restoration process which include as main items the following:
- Whole priming and painting piece by piece
- New front fenders (the originals where in bad condition due to corrosion and bad painting system)
- New rear panels, those located in the corners
- New foam and seat covers according to original specs.
- One wire alternator rated at 110 amp with electronic regulator
- High intensity beams (110W each)
- Pertronix as ignition system and 35,000 V Bosch coil
- Totally new clutch disc, plate and bearing.
- Changed crankshaft rear oil seal
- Gear box and transfer with new bearings and syncro rings.
- Installed AVM lock hubs for easy drive in high way conditions.
- Engine in good conditions with vacuum readings steady and compression test around 130 psi
- Switched from VC to VHA carburetor using brand new carb kit.
- All instruments working as they are supposed have to do. Installed additional voltmeter and vacuumeter.
- Tires 31x10.5xR15, the rear fenders where modified a bit to give enough space for the tires.
- Spring leafs and shackles are the original size but some of them new because were broken
Ok, that is what I did in my Patrol, another story is how much I spend on it,
Anyway, now is time to enjoy it as far as I can.
Thanks Esteban for inviting me here, is a very nice place.
I am Pancho another Patrol addict as Esteban says
- Whole priming and painting piece by piece
- New front fenders (the originals where in bad condition due to corrosion and bad painting system)
- New rear panels, those located in the corners
- New foam and seat covers according to original specs.
- One wire alternator rated at 110 amp with electronic regulator
- High intensity beams (110W each)
- Pertronix as ignition system and 35,000 V Bosch coil
- Totally new clutch disc, plate and bearing.
- Changed crankshaft rear oil seal
- Gear box and transfer with new bearings and syncro rings.
- Installed AVM lock hubs for easy drive in high way conditions.
- Engine in good conditions with vacuum readings steady and compression test around 130 psi
- Switched from VC to VHA carburetor using brand new carb kit.
- All instruments working as they are supposed have to do. Installed additional voltmeter and vacuumeter.
- Tires 31x10.5xR15, the rear fenders where modified a bit to give enough space for the tires.
- Spring leafs and shackles are the original size but some of them new because were broken
Ok, that is what I did in my Patrol, another story is how much I spend on it,
Anyway, now is time to enjoy it as far as I can.
Thanks Esteban for inviting me here, is a very nice place.