60Patrol

I'm having problems finding correct D Bushes.

I ordered Nolathane part no 42075 but the inside diameter was 23mm but my 1868 G60 has 20mm sway bars. The other dimensions of the D Bushed were perfect!

See http://www.nolathane.com.au/product_det ... 75&sq=6753

Both front and rear D bushes seems to be the same size.

I have lodged a request with Nolathane.

Any advice on where I can find the correct part (in Australia of possible)?

You might try ordering the stock ones from Nissan. The part number is 54613-44000. It's been a few years, but I was able to get them from Nissan before.

Hi Pete, I Run Nolathane in mine, they matched the original ones that came out of it, mines a 66 model so im not to sure if they changed Sway bar's overtime.

Ill Try and Get some Numbers from our Stock list books at work, cheers mike

Andy from Nolathane responded promptly:

" You can use the Nolathane (42931) Saddles, and the (42920G) bush kit suits 20mm Swaybars."

Brushes about $30 a pair and Saddles about $40 a pair - both on ebay. Its a bit easier and faster than going to order them from Nissan.

Can someone confirm the sway bars are actually 20mm. It a bit hard to measure accurately with all the rust and grime.

Just as an FYI

I called my local dealer here in SoCal, I called CourtesyNissan in TX, and one of the big NissanParts websites and 54613-44000 is now NLA from the mfg ...

I recently ordered a full set from Amayama Trading
https://www.amayama.com/en/search?q=54613-44000++

They were cheap, $3.38 each and shipping was reasonable. I had a total of about $90 in parts and about $20 in shipping from Japan. It took a couple of weeks to get here. I was very satisfied with the whole deal. I also ordered two throw out bearings including shipping from UAE for about $50. They arrived within a day of the parts from Japan.